You may quickly fix the Velop issue by taking into account these suggestions.
Update Velop Software: Navigate to Linksys' web administration website to install the most recent Velop software. Tap on firmware after that, then select the network advanced settings option. Install the most recent software file on the computer right now. To finish installing the software, restart the Linksys Atlas Velop device.
Atlas Velop reset: The Linksys Atlas Velop device has a reset button on the bottom. Insert the hairpin into that reset button and press it. The Velop LEDs will all be turned off at this point. As a result, the setup has just been totally reset.
Note: After wiping clean all of the previous configuration settings, repeat the Linksys Atlas Pro 6 setup procedure. You can correct any type of error in the Velop device by paying attention to the two approaches' phases.
